Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX Spline measuring issue!

Status
Not open for further replies.
Dec 28, 2020
5
Hi,
Need help to fixing NX-11 Spline measure like this Sloidworks sketch (Spline measure). Is there any alternative way to do this? I am unable to manage spline point and handles option like this picture.
2020-12-28_14-50-56_nq3ja0.png
Link.

Thanks.
Ruman
 
Replies continue below

Recommended for you

in a sketch put your points
as in your picture.

and then use spline through points.
 
Thanks, Ehaviv. Please watch the video(few minutes)! It's just screenshot. I need to draw a new sketch in NX like this video. Just spline issue unable to get the spline measure.

Link
 
Hi Ehaviv, many, many thanks. Thanks a lot! It's clear to your 1st part file. Thanks for your other files! [bigsmile] [2thumbsup]
 
Hey, Ehaviv, can you help me again for second step spline measure? From the video (3:41). Little confusion, Please? And what does the blue value mean of spline?
 
I think it's a curved radius.
but I don't sure.

I never used SOLIDWORKS.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor