Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME PTB-4

Status
Not open for further replies.
K.P.M.

K.P.M.

Mechanical
Jun 5, 2015
38
Hello everyone,

Is ASME PTB-4 mandatory to busy for ASME approved organization?

Regards,
Kejul
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Not exactly sure of what you are saying, but it is not mandatory. It is listed in APP 10 however, as a way of verifying computer program calculations.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Khalid Hameed
  • Question
ASME B 31.3 and ASME B31.8
Replies
4
Views
1K
Khalid Hameed
Khalid Hameed
C
  • Question
ASME VIII-1 Appendix 2 integral flange (Figure 2-4, Sketch 5/6/7) - hub internal to shell boundary permissible? 1
Replies
12
Views
3K
COpressurepipe
C
teokal
  • Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
775
teokal
teokal
WE.MetE
ASME - acceptable material editions
Replies
0
Views
710
WE.MetE
WE.MetE
tigny
  • Locked
  • Question
46-4 DESIGN BY ANALYSIS ASME BPVC.VIII.1 2
2
Replies
22
Views
265
TGS4
TGS4

Part and Inventory Search

Sponsor

Back
Top Bottom