nx teamcenter assys not updating

Do these lower assemblies, components of the lower assemblies have over-ride position turned on?

NO they do not

Verify that your LOAD OPTIONS are to what we have set, with the one suggestion.



Jerry J.
UGV5-NX1899

nyssa68 said:

...we are currently having issues where part from lower assemblies are either not updating or moving position.

Click to expand...

Note that if you open an assembly while someone is working on a component, their changes will not automatically show up in your assembly. If you know (or suspect) that there have been changes in the components, you can use the "close and reopen all modified parts" to see the latest changes.

Also check your revision rule in the assembly load options. In jerry's pic, it is set to "latest working", which is a popular setting (I think it is the TC default). Note that if an assembly has been saved "precise", the latest part revisions may not show up when you open the assembly. A "precise" assembly will open exactly how it was saved, regardless of new part revisions.

www.nxjournaling.com

There are several "delay options" which should be checked.
Menu- tools- Update- ... etc
if there is a "tickmark" in front of the line, it is delayed.
Does this change anything ?

Can you elaborate on the "does not update", is there new revisions not showing up, new versions not showing up ? ( in TC each time you save, it will save a new Version, this can be set by the teamcenter owner if or how.

Regards,
Tomas

The more you know about a subject, the more you know how little you know about that subject.