Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ISO 8573.1 Air Quality

Status
Not open for further replies.
dogbural

dogbural

Aerospace
Jan 25, 2009
74
Hi,

I would like to measure air quality coming from compressed air that used for CNC machine.
I am wondering if there is any hand held device to measure and check if it is compliant with ISO 8573.1 Class 1.4.1.

Please advise.

Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I dont have the answer to this question, but if your air compressor is not an oil free machine, it is unlikely your product air to CNC machines meets the residual oil requirements for class 1.4.1. And so too for your water dewpoint of 37degF at operating pressure.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

helpyou
  • Locked
  • Question
Converting air failure position for valves
Replies
2
Views
90
bcd
bcd
helpyou
  • Locked
  • Question
Actuator air leak
Replies
3
Views
108
G.Ramesh
G.Ramesh
ipocoyo
  • Locked
  • Question
Is there an instrument can monitor volume of air?
Replies
10
Views
78
hacksaw
hacksaw
clandestinho
  • Locked
  • Question
selecting a temperature sensor for air/solvent vapor
Replies
9
Views
103
danw2
danw2
bowman30
  • Locked
  • Question
Instrument air consumption calculation
Replies
6
Views
237
bowman30
bowman30

Part and Inventory Search

Sponsor

Back
Top Bottom