Looking for PED vessel mfgrs 3

Hi monk75 (Industrial)

The following link has the e-mail address for contact.

Contact your AIA.

Try: sales@fultonenterprises.com

There is a list of approved PED Manufacture in the LOWER 48 United State. Send me a e-mail

Leonard@thill.biz

Monk75,

We have the capability of manufacturing PED pressure vessels (ASME U Stamp, ISO 9001: 2000, Pressure Equipment Directive 97/23/EC: Module H), and although located in Florida, our prices are usually very competitive. Please contact me and I'll see if I can help you out.

Regards,

Chris Roy

croy@microflexinc.com

I'd like to thank everyone who has responded to this post. I asked the same question on the CEN/ECN site and haven't gotten one reply.

Thanks again,

monk75

We are located in Italy and manufacture pressure equipment, mostly Heat Exchanger, according to PED directive, with module H and H1 with Det Norske Veritas notified body. Consider that our typical dimension are not so big (consider up to 20" diameter).
luigi.guzzi@flovex.it

Before PED all manufacturers in Spain were registered companies but lists are not in e-format as far as I know.
Now this register doesn't exist.
You can browse for words "depósito recipiente presión caldera calderería reactor autoclave" or look for yellow-pages lists or asociations, for example;
Companies in Catalonia
Air vessels:
Metal constructors
My top ten (not all they are):
SS vessels and heat-ex for chemical industry
Aguilar y Salas, S.A.
E. Bachiller b., S.A.
SS vessels for textil industry
Argelich y Termes, S.A.
Fired tubes steam boilers
Valtec-Umisa, S.A.
Instman Field, S.A.
Moiman, S.A.
Water tubes steam boilers
Calderas Woga, S.A.
Carbon Steel for gas vessels
Calderería Egarense, S.A.
Heat-Ex for petrochemical
Compañia Española de Calderería, S.A. CECSA
Air industry
Novair, S.A.
Hope this helps


Regards from Barcelona
G. García

Try Hebeler Corp, 2000 Military Road, Tonawanda NY 14150
716-873-9300. They have done alot of PED for GE.

monk75,

We are a Pressure Vessel / Heat Exchanger manufacturer based in the UK. We are able to manufacture pressure vessels to the Pressure Equipment Directive (dir.97/23/EC), and are also a U-stamp shop. We manufacture a range of standard vessels aswell as bespoke one-off designs.

For further information or to place an enquiry please contact us.

j.simpson@stanref.freeserve.co.uk

Stanref International Ltd
Northern Way
Bury St Edmunds
Suffolk
IP32 6NL

+44 (0)1284 763501 (t)
+44 (0)1284 750052 (f)

Why don't you make the vessels? You don't have to be approved to make vessels to the PED. You may need the services of a notifief body to inspect them, depending on there risk category.

You can get a free copy of the PED from

Regards

John