Recent content by ARToolingEngineer

Greetings, I have a detail that I need to place 2 holes into it. I would like to use features from the assembly where this detail is installed. Is this possible to do this? Thanks, Brent

Cowski, Thank you for showing how to do it. I do realize this is a bad practice, we just had a unique situation that warranted this option. Thanks again, Brent

Greetings, Can anyone show me how to Override a Dimension? Thanks, Brent

Oh, actually, I see now. You go to where you placed the Detail View. I'd much rather it be from where you select the 1st region so that you know what size you actually need. Quirky, but I'll get it. Thanks for the response.

Thanks Cowski, for some reason, the rectangle is shown while I drag it out, but turns into a circle once I complete the region.

Greetings, 2-Fold question on Detail View 1- After I've created a Detail View, I added a component outside its boundaries and need to enlarge it * I do not see an option to allow the size to change 2- One of the Detail Views, I prefer it be rectangle. I see the rectangle...

Cowski, Very nice, thank you. Brent

Greetings, Would someone show me how to find center of gravity of a weldment that includes several solid bodies? Thanks, Brent

Hi John, Only a visual representation.

Greetings, Wondering if there is a way to put a knurl finish on a diameter handle body? Thanks, Brent

Ok, got it. It was an old file, so not exactly through the center could have been the issue. I replaced the entire section and 3-D Centerline worked fine. Thank you for the reply, Brent

Greetings: I am drafting a part, and created a section view to expose specific holes that I want to describe from within the section. When I select 3-D Centerline, the holes are not recognized to place the centerline. Am I doing something incorrect? Thanks, Brent

Ok, thank you SDETERS. It does make sense. Sure would be nice to simply be able to select any Arrangement that has been created. Anyway, thanks again, I'll give that approach a shot.

Ok, thanks Jerry, I will check those out.

I meant to type, I am now interested.. not ... not. Anyway, if someone could lend a helping hand on the subject above, that would be fantastic. Thanks, Brent