Recent content by BrittToolEngineer

Greetings: I'm new to the NX1926 version. When drafting, my centerlines come in at a 25 thickness. I would like to change this in settings, but have not been able to find it yet. Can someone help point to where we change this setting? Thanks, Brent

That helps. Thanks Jerry

Greetings: In NX 12 and prior, I was able to measure the actual weight of a body. I'm not sure where to find this command in the latest version. Can someone help point the way? Thanks, Brent

Picture attached may helphttps://files.engineering.com/getfile.aspx?folder=01979148-a0af-418c-91fa-96a7b1445e4d&file=DIMENSION_ISSUE.pptx

Greetings: I have a part nested into a fixture. I took a section view of the round assembly. When I go to dimension the fixture and the part, the dimension will not allow me to select say an endpoint on my part. I use to grab endpoints from components without issue in NX12 and earlier. I...

I just learned from one of the NX trainers that the new version has a new feature called "Project Point onto Target". They are trying to reduce or eliminate users from having to project geometry to create holes.

Some more information, the hole command will recognized body features and sketch features, but not a projected circle?

Also, I just noticed. I created a sketch to make the first set of holes (and like I said before, I usually could use those holes to create the holes in the next body), the sketch geometry allows me to select; however, the projected geometry does not. hmmmmm ????

I believe I'm working in single part file with multiple bodies.

Greetings, From NX12 and prior, I was always able to create a hole, either threaded or whatever, from a projected circle or even from the bottom of a clearance hole of a body that was directly on top of another body. Now when I attempt either of those in NX 1926, after clicking the hole...

That did it. Thank you Anthony

Greetings, We are now using NX 1926, we used to use NX12 and prior. I am currently attempting to project a curve from an imported .prt file. It seems to make that part file the current work feature (the one I need lines from), then when I go back to work on Displayed Assembly, the curves go...

Greetings: I am currently drafting a part from a previous file and when I rapid dimension, I have the settings set for (3) decimal places. Some of the DIMs show up as 3, some 2 and some 1. I have set my preferences accordingly. When I double click a single decimal dimension, it shows it set...

Greetings: In NX12, when drafting, I am able to type the letter "L" and this begins sketch mode with the line command. In NX 1926, when I type the letter "L", nothing occurs. I have to find the line command in the sketch application to perform this. I'm wondering if there is a toggle...

Found it. Thank you Toost