Hey looslib, thank you for your reply. I forgot to include the second example, sorry... I already thought of wrong units but another example in the same programm is:
Floor milling, tool diameter=116mm, surface speed=110m/s, feed per tooth=0.05mm, 4 teeth, sprindle speed=302rpm, cut feed...
Hey all,
I am currently exploring NXCAM and I have a small discrepancy between my setup and the G generated code.
Example: Spot drill operation, tool diameter=3.15mm, surface speed=35m/s, feed per tooth=0.125mm, 2 teeth, sprindle speed=3537rpm, cut feed rate=884.25mm/min.
Now in the...
Hey there,
I have a short question regarding a drilling operation in NX CAM.
It's a simple spot drilling operation, nothing fancy. But in the simulation, the drill turns red for a moment which is a little irritating.
This happens once when the drill has almost finished the hole, and again when...
Hey everyone,
I have started using the Mouls Wizard in NX 9.0 a few days ago and I have some issues when I want to open a project.
So when I open my part and initialise a new project in the Mold wizard, I can use all functions properly. When saving, several dozen files are created in addition...
