Hello,
The brushes were changed because of the manufacturer send this brushes saying that they are the correct ones.
The machine is kind of extruder, where 4 motors work in parralel.
I am not sure what exactly do you mean by PCM, but even if it is available we cannot use it, because the motor...
Thank you for your answers!
dArsonval,
If I understand correct your english you doubt that the brushes were replaced?
If so the brushes were replaced before 1 month with original brushes sent from the manufacturer (firstly the motor was with EG283 then with EG571)
"molten tin/slash solder...
Hello again!
We did all the things you suggested in this post, even more - setting the neutral, the brush-holder height, the mica, ordered original brushes from the manufacturer, dynamic balancing and etc...
The motor worked fine for a month or this is what was told to us
Yesterday they called...
Hello,
I am still trying to get some official information about the winding of the compressor mentioned in this thread: http://www.eng-tips.com/viewthread.cfm?qid=359153
When reading several books, I noticed three strange type of connection diagrams:
Adjacent pole
Skip pole
Consequent pole...
The old winders in our repair shop have a "rule" which is the Nominal current divided by 8 (In/8) and then they choose the next larger size of cable (in sq.mm)...I found that this works for delta motors, for wye-connected, multiply by sqrt(3)
:))
www.eldvigateli.com
Hello all thank you for your answers!
The motor is exactly as you said 36 slot stator, 12 groups, 8 groups of 2 coils (SPAN 1-8, 1-10) and 4 groups of one coil(SPAN 1-8)
I said that you "can count" 24 groups, because the coils are kind of "doubled".
For example: From slot Number 2, are going...
Hello,
I finnaly opened the winding.
Actually you can count kind of 24 coil groups, instead of 12.
They are placed as you see them in the picture, one above the other. All the connections are as in the picture but the coil ends are splited for the part-winding.
www.eldvigateli.com
Hello,
Thank you for your replies!
The winding impregnation is very hard and it is very dificult to take the connection, that is why we are so slow
This is the correct position of the coils:
The strange thing is that from the same slot and coil goes out two "coil end"
Other strange thing...
Today we started to open the connection of the motor. The strange thing which is different from the first picture which @MotorWinder showed (4 pole, Delta connected, Part winding, Adjacent Pole, 2 Circuit), is that there are connections with 3 leads.
The other strange thing in this point (where...
Thank you very much @Motorwinder!
One more hint please:
How to read "Coil end No"?
1 is the beginning of the first coil and 2 is the end of the first coil
3 is the beginning of the second coil and 4 is the end of the second coil
5 is the beginning of the third coil and 6 is the end of the...
It looks a lot like this (delta/double star) :
http://www.nzdl.org/gsdlmod?e=d-00000-00---off-0gtz--00-0----0-10-0---0---0direct-10---4-------0-1l--11-en-50---20-help---00-0-1-00-0-0-11-1-0utfZz-8-00&a=d&cl=CL2.1&d=HASH01693eebdf3891bea95c4ae7.7.4.2
But the K2, closing the star is missing...
