Yes shear on threads. I thought someone was asking if the bolt itself was in shear. Its the bolted plate scenario, tensile in bolt direction. I have used multiple formulas and have come up with the same number. Is that in PSI and if thats the case do I multiply the area of the bolt x the psi...
See if my math works: 10mm bolt = .375 shear dia x pi x thread eng x material shear strength = .375 x 3.1415 x 1" x 2922psi = 3442psi thread pull out. Hard to believe.
I have some 8.8 10mm metric bolts that will experience load in tension. Rated at 830mpa but I am thinking I should be more concerned with thread pullout then tensile. I Could not purchase 10.9 bolts so was wondering if these would work and what the calculation would be for the thread pullout.
Can you guys tell me how to figure out this wiring problem. Only one bar is disconnected. All others have continuity but I have 3 loose wires. 2 have continuity to each other only, the other has continuity to all the bars. How di I wire this back up?
interior storefront. pleanty of reasons like a one hour rated corridor. maybe in a school , an admin office off a corridor where you can see thru into the office or classroom. i think i have seen these online but someone told me you need wire glass for 1hr rating.
