Recent content by Fariborz90808888

[smile] thanks a lot Greg Locock that's what i did... also a reverse gear was in order... but would i also succeed in doing this with positive (1 to 5) gear and not a reverse (-1) gear? would this be possible?

hi everyone i'm trying to build a reverse gear event such as fishhook with the vehicle going backward or J-turn with the vehicle going backbard (in reverse)... would you please help? thanks a lot by the way because of many helps i have received in this site

thanks a lot appreciate your help

thanks as always... i will try that how should i do that? i know about the error in the solver setting but how about the iterations?

FYI the interface that i have created is placed on the twist beam and is the location of the bumpstop which is placed on the twist beam...

hi everyone thanks for helping a lot when needed i have made a twist beam suspension model assembly on a testrig and when i get a test when performing it on the wheel centers instead of the contact patch, i get this error: Static equilibrium analysis has not been successful. The maximum...

hi i'm trying to create a result component or a request that can contain a function would you please guide me through it? thanks a lot

thank you Greg Locock and newbie_user for helping great help appreciate both of you guys

thanks a lot Greg Locock for helping a lot as always but can i have the stiffness parameter itself since i have selected the linear bushing which uses constant parameters, as the Insight Factors? how can i define a variable for bushing stiffness in adams/car for which i can have a factor in...

hi i'm trying to optimize the front suspension bushing stiffness constituents in a full vehicle model in adams/insight? when i look into the factors of the said bushing i can't see the stiffness factor. the image is as below: how can i do that? how can i optimize the bushing stiffness or...

thanks for helping a lot helped me every time

thanks a lot [peace]

hi i tried to edit some of the data in the engine property file model in notepad and i started getting this message... the problem is that i had saved the original file and i'm getting the same error from the original file... please help the error is as follows: Reading in property...

in a step steer test i see an almost constant 0.37 deg steering wheel angle ... that's what i call initial steering wheel angle...

hi Greg Locock i have used symmetrical coordinates for the tie rods and i still get 0.39 deg initial steering wheel angle... couldn't it be from the driver? or the unsymmetry of the whole vehicle? thanks for helping me a lot in this forum