Recent content by hookie1985

We run vpss 3i. Basically the software has given more power to the computer to make decisions. Its sad to say I preferred DR. Abe over it. We also have a rotary index though so I have 3 different software's to use to make a single round part. Unfortunately they kind of have the market cornered...

mine is under preference>nc out put

right on, thank you

did you get the cone from advanced laser service?

yeah thar too lol

i pulled the lines and it still did it though?

you're gonna want a funnel with a long flexible tube on it. otherwise its pretty straight forward. just make sure you don't overfill it

Good call. Any idea which one it'd be?

So our machine will run fine for 3 to 4 hours till its warm, then when it goes down to cut and the shutter opens it raises to z+ over travel, I swapped heads, pulled the lines and ran without them to see if they were messing with the sensor, and tried different programs and cut conditions. Any...

i currently have the wires jumped to get by time being. i put the mirrors directly in front of the emitters and taped them on and it still wouldnt reset

thanks guys, i think our reflectors are screwed. someone hit them and they cracked

Does anyone have a picture of the alignment tool used to align the safety fence beams?

What spyder said is legit. he's saved me a few times

Easiest thing to check is if any of your lines that connect to the cone are touching the cone. it will cause that to happen and give the alarm. if That doesn't work you can try hooking up the external cable if it came with one

What does this mean?? our laser keeps saying this when we try and open a program. any ideas??