Hi Ken,
Someone in that site deleted my comment asking, what is the logic of selecting a third plane in which the dimension lies (in Angular dimensioning).
Even if that confusion is stupid, no need to delete it.
syam
Also if the part is made in a forming die, forget about solid edge, you have to use Fastblank for getting almost correct blank. More complex the shape, less accurate the blank.
Hi SwenBom,
I give up since time is the issue, We outsourced that to people working in C4D.
From my side I have simplified the assembly ready for animation (reduced the total size from ~3,8Gb to 120 Mb, all moving components seperated and identified and prepared the sequence chart.
Now back into...
Hi SwenBom,
Firstly thanks for your time. I have got some tips from that.
My layout is slightly different. It is a closed chain. The pallets travels one by one in X-axis and stacks in Y-axis.
I found one motor on a different machine is causing the problem, but how? I dont know, these two...
I have deleted the motors and created new one, still after ~50% movement the component jumps to one side and start the rest of the event from there.
This time I had taken care all parts are active from creating the motors to animation.
I have tried to use different constraints and even tried...
Hi All,
I was making the plant layout and animated it with 20 motors (16 linear).
During animation, some componets moves out of the building in between an event.
I have tried so many things and failed, like delete the motor and add it again.
It is a lot of work to make all this sequences again...
Hi SvenBom
Thanks for the great help.
I am able to do that keeping start and end 0% visible. then to show another 2 framed appearence event from 0 to Part style. I have tried but not successful in the second procedure. can you please explain more.
syam
Thanks Scott for saving my time serching this, in solidworks we were able to open (If the drawing is in the same folder and same name)
Also is there a global scale factor for the Hatch spacing (to change hatch spacing for all materials and in all views of a sheet)
Thanks xedu, I am working in a German company but unfortunatly that software doesn't support 64bit Solid Edge, Think I have to do my 20+ first level subassemblies (may be a countless second, third and fourth level also) like what KENAT said.
Hi beachcomber
Thanks for the suggestions. when you speak I will hear with respect since I have already learn so much from you, and my problem, maybe I have switched from Solid edge V19 to SW2008 without any training & never stuck somewhere. while coming back from SW2012 to ST5 I am so excited...