Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. JerROD

    Solidworks error Message

    Thanks for both of your posts. I ended up separating the geometry, and then joining them with a rectangular sweep in the centre, worked out fine. I just had to add one operation where I did a revolve cut to smooth the outer surface. Cheers
  2. JerROD

    Solidworks error Message

    Hello, Recently, I've been trying to draw a rather complicated feature in Solidworks 2006 SP5.1. Basically, picture a sort of auger with varying flight widths and pitches. In order to achieve the varying flight width, I break the flight into two sides (Following side and pushing side) and I...
  3. JerROD

    Changing alignment of views in solidworks drawings

    Thanks for the quick response guys, very appreciated.
  4. JerROD

    Changing alignment of views in solidworks drawings

    Hello, I'm drawing a top view of a part, and then a side view branching off too the right. Then I want to take a section view of the "right view" so that the section is the same orientation as the "top view" of the part. The problem is that it seems impossible to make that section view align...
Back
Top