Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. VenkyS1

    Scheduling (activation-deactivation) of motors

    Thank you very much. It helped!!
  2. VenkyS1

    Scheduling (activation-deactivation) of motors

    Hi, I have 4 motors (taken from "machinery" in Adams). I want two of them to run first and later switch on the other two. Is this possible in Adams? Thanks in advance
  3. VenkyS1

    Adams/matlab co-simulation

    Hi, I am trying to do a matlab - adams co simulation. The model built in Adams is perfectly working and am able to get a complete simulation run. When I try to do the same from Matlab (after exporting a Adams control plant and giving necessary inputs from Matlab), the error shows up...
  4. VenkyS1

    Error while simulating

    Hi, Yes I have. I did the initial conditions simulation to check and it says "There are no redundant constraint equations".
  5. VenkyS1

    Error while simulating

    Hi, I created three wheels and clamps to hold them. I gave rotational motion to the three wheels (connected to the clamp to check) and they were rotating perfectly. As soon as I try placing a platform on top of them (so that I can apply a load and analyze)it shows an error. The wheels which...
  6. VenkyS1

    Create joints after in MSC Adams

    Hi, Thanks for your answer. I missed the coincident part. And also there is a small button in the bottom right which makes you view the markers and joints. I disabled this previously, so nothing was visible.
  7. VenkyS1

    Create joints after in MSC Adams

    Hi, I have imported two iges file into adams. I now want to create a cylindrical joint between them. I have selected the joint under "connections" and clicked on the two bodies in contact. While I want to create the "location of the joint"(final step) neither the cm nor the marker are...

Part and Inventory Search

Back
Top