You sould be able to access the spreadsheet over your network on any PC without changing anything. As long as the RSLinx PC is on the same network. We do this with our InSql data, which should be any different than getting the data directly from the PLC.
Open the file that contains the database, clic save as and check the Save database as a external file box. Then, open the program you want to import database and clic tool --> database --> native import, clic ok. That should be what you are looking for. I don't think RSLgx-5 handles them in a...
Wouldn't removing the 1:2 speed increaser decrease the load on the motor? If this is the case couldn't he use a smaller hp motor? Thus increasing his savings.
The panelview should have no problems using the UDT's. I know we do use some like this. But I don't work with the panelviews very much and I was not aware of a PV+RSView. I will look into the PV's that we have and check this out for you.
You can view code from RSLinx but I would not suggest doing so. When searching for a address you must search each file seperatly. It does not search the hole program buy it self. Like EddieWillers said you can only browse it will not allow you to make any edits.
We actually have an application vey close to this, except on a larger scale. One thing you might want to look into is instaed of 3 sensors switch to one analog sensor. Then you can use it's value to turn things on and off as you wish. Then you could also display the actual level on your screen...
No, No there was no misunderstanding. You gave him the exact info I was looking for. I already knew the continuity and to ground. I just wasn't sure of the windings to windings test.
Again thank you.
I was hoping someone would know where I could find the proper testing procedure (megohmmeter phase to phase)for a dual voltage 9 lead wye connected motor? I found one for 9 lead delta at aemc.com but I cann't find one for wye connected.
Any help would be greatly appreciated