Hello All,
I made a drawing and inserted a dimension in NX 7.5
on the chamfer dimension (3mm) I couldn't reduce the arrows tails, except for one side if I move the digit 3 toward the center.
thanks a lot in advance
Hello all,
thank you for your answers. here's a sketch.
the tube is DN50.
thanks a lot in advance.http://files.engineering.com/getfile.aspx?folder=ee852603-8309-4893-b642-86382b860c00&file=flangless_tube.bmp
Hello all,
I have a flangless tube to install for a short time on a line and I'm strugling to make it watertight.
I tried to make flanged connections where the flange is bolted to the line's flange and the other side is only a simple tube of the same OD & ID of my tube.so the arrangement look...
Hello John,
I actually meant the parameter to control the size of the extrusion.
seen from that point of view it's not vital to do it my way it's just easier to understand the construction without referring to the list of expressions when the part is reopend.
I take it that it is not the way...
Hello,
I'm using NX 7.5 and I have a little problem with dimensions.
I would like to create a symetrical extrusion and be able to dimension the whole body and not only half of it.
anybody knows how to do that?
thanks a lot in advance.
s.y.
Yes that's what I meant.
While in drawing I used the direct sketch tool to draw the curves.
I did skip the selection of the corresponding view, I did it now and it works very well. so thank you loads.
Hello,
I'm trying to create a break view section of a projection view. my problem is that I can't select the chain of curves around my projection.
did this problem occur often and does anybody have a solution?
thank you very much in advance.
Hello nutace, Jerry and sdeters,
your methode does work but I still can't select any element of the datum CSYS to costain the other parts to it.
is it allowed to constrain to datum CSYS in NX7.5?