Hello everybody,
As in subject, is there a way to get values from free body cuts by python script?
I'm still searching, but it look like it is only possible to do it by hand...
Help!
Regards
Tomasz
Do you try to change minimum increment size in job defining? Sometimes 1e-5 is to low. For steel properties sometimes 1e-7, 1e-8 is proper, especially with contacts.
Hi,
Try to change first increment size to 0.01, also important matter is what amount of pressure do you apply? Is this reasonable value or you simply apply "something large enough"?
Look into this chapter of Abaqus Example Problems Manual:
- 1.2.3 Buckling of a column with spot welds in Abaqus Example Problems Manual
They use fasteners.
If I remember correctly, you can simply create new job in abaqus/cae and instead of model you can mark inp file (dropdown list model/input).
regards
Tomek
You could also try to preload with small displacement to close contacts or (I never test this, but I heard that it sometimes help) simply leave "empty" step to let solver find all contacts.
regards
Tomek
Hi all,
I'm trying to model very simple version of ball bearing.
Problem shows when I create "cycle wheel" instead of ball. Abaqus create hard point in every point where wires crossing each other. This causes that there is always a point in the centre of wheel. Which during analysis is blown...
Hello everybody.
I'm new at the forum, so Hi again.
From my experience. Pressure distribution you usually receive from specialised software for hydro analysis (if you do global analysis, as in this case). All the motions and accelerations are also transferred or read from hydro analysis.
For...