Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. PhilMetal

    Partition advice

    Yes, the pressure load is only applied in that little section. Thank you for the information about the non-axisymmetric elements. I was unsure how to account for the load with axisymmetric elements, but it makes more sense now.
  2. PhilMetal

    Partition advice

    Thanks for the suggestions. I will give both a try.
  3. PhilMetal

    Partition advice

    Hi all I'm simulating a pressure load on a 2x2 partition at the surface of a quarter-model tensile specimen (screen shot is in the link below). So far I have been using a structured mesh technique but there are some distorted elements close to the centre of the model due to the way that I...
  4. PhilMetal

    Import initial velocity from previous analysis

    Have you tried copying your original model to a new model and assigning an initial state predefined field (based upon the output from your original model) in the copied model?
  5. PhilMetal

    Import initial velocity from previous analysis

    Are you asking how to import velocity output data from one explicit analysis into the initial step of a new explicit analysis? Or have I misunderstood your question?
Back
Top