Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. JustinFFE

    sketch from DXF issues

    I'm having some issues importing DXF's for a sketch. When i place the sketch and scale it appropriately the sketch erases and an error comes up reading " section solve failed". I'm not sure why i looked at the dxf and it's a closed polyline in autocad. No dual entities either. Any help
  2. JustinFFE

    AB Powerflex 70 [VFD]

    It wasn't ran but was plugged in. Going through the manual I did change some settings to match the motors name plate. We're currently getting a Digital interference fault so i've contacted our controls engineer and he is taking a look at it. Thank you for all of your help guys.
  3. JustinFFE

    AB Powerflex 70 [VFD]

    I haven't tried to disconnect the VFD and just run the motor I will. The VFD has been configured a couple years ago with the same 2hp motor.
  4. JustinFFE

    AB Powerflex 70 [VFD]

    hey guys, i'm an ME intern at a company and was given a project that is utilizing an Allen-Bradley Powerflex 70 adjustable frequency drive. I downloaded the manual but am not an electrical engineer so a lot of it is over my head. The machine is a simulated engine valve train that is spun...
  5. JustinFFE

    Creo-Hole Callout Not appearing

    Thanks guys. Its mainly just some Counter Sunk holes clearanced for SHCS. I will just enter it. Now to figure out why my BOM's aren't working correctly haha.
  6. JustinFFE

    Creo-Hole Callout Not appearing

    Hello all, I'm currently having an issue with the annotation of holes. for instance I have a CS hole that is just a thru hole clearanced for a SHCS. But when I go to "Show Model Annotations" under the dimensions the diameters show up but when i go to the call out tab it doesn't show up. It...
  7. JustinFFE

    High Volume Chemical Pump

    Hey guys, I'm currently a ME intern and am working on a project that requires a high volume chemical resistant pump. I'm developing an automated chemical delivery system for metal finishing. The chemicals are highly caustic and I can't seem to find a pump to move the volume of fluid I need...

Part and Inventory Search

Back
Top