Search results for query: *

Hi T moose, rotation is very seldom, the load is only around 100kg when need to rotate and it will be very slow probably 15 sec/rotation. rotation will be manual using a gearbox directly mounted to the shaft.

Hi Greg, I will not be using 303 now sorry about that. Ya 304 or 316 will be the material.

Hi rb1957! Ya normally I do that, its just that I want to show in calculation how these 45 braces help in reducing the deflection. Mmmm, well I guess as long as the deflection calculation without the 45 brace is acceptable then should be all good, the 45 braces will be there just for added...

Hi Greg! Thanks for your feedback. I guess Im just going to make some calculations on the center (in the red portion you highlighted) with a safety factor of 3. I think it will be a good start for the calculation. Thank you very much.

Wow thanks for the replies guys thats fast. Actually Im trying to make some calculations for the design below. It is a frame with caster wheels, as shown below. im trying to see how this 45 angle supports will help in the reduce deflection of the beam at load and I need to show it using...

HI Guys! I just wanted to know how to calculate the stress and deflection of a frame shown below. Thank you for the help. Cant sleep because of this.

that was great greenimi!! Thank you very much!

greenimi that was very informative. THanks! By the way may i ask, can you use a profile tolerance to control the position of a surface? you may refer to the drawing again and see the profile tolerance control. if i want to control the position and angle of the locating block, can i use a...

Hi Guys, Need Some help. Im new in designing checking fixtures and gauges. can somebody tell me if there is something wrong with the tolerances I put. I need to check a part's arc length by using Go Nogo gauge. the part image below and its tolerance. to use the gauge is by sliding the...