You can do so by creating a couple of configurations where pin would be in two extreme points of the slot.
Or use a line between two pionts of the slot and one of the planes of the pin. This will give you sliding direction. Set two limit distances(in advenced mates). Also you need a third mate...
Here is a solution that can only be applied to a part file:
In custom properties create a stock size field that would be driven by nominal dimensions of the part. Make this part a part template and use it for every new part you have to make.
One very important thing to keep in mind – you can...
Check if your linked text in title block says $PRPSHEET and not $PRP.
It’s a bit confusing, but $PRPSHEET actually refers to the part / assembly inserted into the drawing, when $PRP – the document you are currently working with, which is your drawing…
And how do you link it with quantity? Are...
SBaugh,
The hole callout for the new holes doesn't work...
It doesn't recogrize them as tapped holes of the hole wizard.
For M8x1 it gives me 7.0 dia. callout.
Am I doing something wrong?
Thanks.
Is there a way to modify Hole Wizard, so that there are fine metric tap sizes such as M8x1 or M10x1.5, M18x1 etc.
I’m trying to eliminate manual typing, which leaves too much room for errors.
As of right now, I have to change the “M10x1.75 tapped hole 1” to “M10x1.5 tapped hole 1” in the...
The easiest way to make a slot on a single part that I found is to use slot under tools- feature palette - palette fetures - machined... There is also a curved slot. For mating you should consider using scetches. I modify the scetch of the slot by adding a couple of points. These new points will...