Search results for query: *

Hello Everyone, I need some advice, I've been out of work for quite sometime now but I have an interview scheduled for this coming Tuesday where I will be tested on my Pro-e ability. I was a long-time user before I lost my job but I'd be lying if I said I wasn't a bit nervous. I know I have...

I found the help docs and created a break-out view. Thanks for the assist!

I need to clarify one point. Using UG terminology, I'm not looking to do a broken view, rather a break-out section view. Sorry for the confusion.

Ok, that sounds like a good place to start. I've already gone through the CAST online training but where or how can I access this user documentation? In Catia, I could hit the F1 key mid command to get detailed info on how to properly perform that feature. When I hit F1 in UG, I get nothing. Is...

I've only been using NX4 the last three weeks and I cannot figure out how to make this view in a drawing. It's pretty easy in Catia but I'm missing something. Thanks!

Thanks for the tip, that did the trick! I'm still working on the default 2D color option but at least I have a few ideas.

All of our settings and standards are pre-defined by our German office. However, I have the ability to modify some settings based on our needs here in the States. OK, under the Tools\Options\Drafting\View Tab, All of the options in the Geometry Generation / Dress-up are greyed-out so I cannot...

OK, I'm using the Admin mode and I'm trying to define drafting standards but seem to have a problem. I cannot find the 'setting' for which I can get a dimensions value centered with it's dimension line (gone through the help docs). It's always above the dim line :( I do have it set to ANSI but...

Using V5r13, range is currently set at 1 x 10 to the fifth. I need a setting of 1 x 10 to the sixth. I have a part w/ a r100,000 but I need to increase this to a radius of 1 million. Many thanks!

That did it! Many thanks 1oldcaduser!!

Right now i'm using V5 r12.

Thanks for the info 1oldcaduser. I'm able to define this new "origin" within the part model without an issue but for some reason I cannot get my 2D drawing to recognize this point as 0,0. I tried inserting a new view as a "shot in the dark" because even after an update cycle, the 2D drawing...

I'm trying to "move" my default origin/coord. system to a new location. I created a new axis system for my cylinder along the parts axis/ centerline but at the opposite end of the part. (X=0, Y=-2.75, Z=0 --> position from default origin). I want this point to be my new 0,0,0 so I can place...