hi all,
Defining plasticity card i had to convert Nominal stress - strain curve into True-logarithmic scale.
Let's say A% is 12,2 (0.122) but as logarithic it's equeval to 0.1
Question:
PEEQ values are as Logarithmic or Normal. I set limit for PEEQ in legend but i am not shure that it...
Hi guys,
i have problem with correlation of simulation results with real test data for plastic parts. I am using elastic-plastic material model the same as for steel.
Please, give me advise about how to calculate plastics properly to obtain proper results.
Regards
- check out elements in your mesh (this error comes often with bad element definition)
- check out adjusting at start of analysis (it can deform elements which have adjusted nodes). Try to control it by specifed tolerance value, using nsets rather than specifed tolerance
OK, i resolved that.
Go to "post" submenu then clik into XYPlot. There are tools to create curves which are translated in Abaqus Profile into *AMPLITUDE
Thanks both of You.
I am reading "Scripting User's Manual" and it looks good. By the way, I registered on Abaqus Automation portal, not so hot as i supposed.
Bye, abq656 j=P-06-26 cpu=2
Hi guys,
i am looking for tamplates mentioned in topic. I would like to create input files for that solvers (they are chaper than others :) )
Ah,maybe some links or docs in internet which show me how to make such templates my self.
Thanks..
COEngineeer (Structural) 19 Oct 06 15:30
affordable vacation in outer space
Look at that,
http://www.youtube.com/watch?v=XBlifr6EQNU
It cost only 200 000 $ and start at 2009.
---------------------------
My propositions according to topic:
- Animation software and robots using FEA algorithms.
Hi all,
Lat say, analyse have 80 inc, 1 day calculation and I am looking for Ultimate strength of component. it happens let's say on 56 increment. So, i offen go to ODB Field Plot and create plot for example: UR3 and RF3 than i have to creante equation on them (Operate on XY). Fine, but...
There are not in internet.
Advice:
Install Abaqus and unpack example or benchmark input files. Import interesting file into HyperMesh and look out how it works.
Hi all,
I use HyperMesh 7.0 SP4 and Abaqus 6.5.6
Problem:
Model contain two parts ( slide , bracket ). Engineer have few diferent material proposition for bracket and would know wchich is the best. Because i work with HyperMesh i have to create few hm files and export them to inp files. It...