Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

Search results for query: *

  1. Bartonrj25

    Identifying Altered Items on a Parts List or BOM

    Normally, the raw stock is identified on the BOM by material spec within the BOM.
  2. Bartonrj25

    Identifying Altered Items on a Parts List or BOM

    I would like to know how the original part number or make from part number is identified on a parts list or BOM. My company is inputting our Part list/BOM information into our MRP system by uploading from our drawings. Previously we would identify our parts by flag note "Make from PN 123456" and...
  3. Bartonrj25

    Mulitideatail Drawings with altered items

    Okay, I have the answer I was looking for in the ASME Standard. Here is what the ASME Standards says: NOTE: An altered item may be delineated on the using assembly drawing provided requirements (a) through (e) are met and the item is noted ALTERED ITEM.
  4. Bartonrj25

    Mulitideatail Drawings with altered items

    On a Multidetail Drawing that has Altered Items, do you show the notation "ALTERED ITEM DRAWING" at the assembly level or at the part level? ASME Y14.24 isn't very clear and I would like to interpret the standard in the correct way. Some would say to put the notation at the assembly level and...
  5. Bartonrj25

    Should part configuration have the same FN number?

    Got the answer I needed for this post. Thank you.
  6. Bartonrj25

    Should part configuration have the same FN number?

    Should a part configuration share the same FN number or does this go against a standard or standard practice? https://files.engineering.com/getfile.aspx?folder=1bd2f355-0677-44da-97ff-52acfe913acc&file=example1.JPG
  7. Bartonrj25

    Making section views from a detail view

    Is it bad practice to add a section view from a detail view or does it matter as long as your design intent is captured?
  8. Bartonrj25

    Is there a Mil-Spec or other Standard for applying body filler?

    I was able to source the process through the IETM just as you said WKTaylor. Thanks for the help.
  9. Bartonrj25

    Is there a Mil-Spec or other Standard for applying body filler?

    I am making modifications to the Horizontal Stabilator. Altering from Delta to Echo model. There are two panel access at the rear of the stabilator. The cut-out hole sizes are different shapes and will require body modification. This is a Part Task trainer simulator for the Apache Longbow E...
  10. Bartonrj25

    Is there a Mil-Spec or other Standard for applying body filler?

    It is an AH-64E Apache Longbow
  11. Bartonrj25

    Is there a Mil-Spec or other Standard for applying body filler?

    I am applying a general note for surface prep and application of body filler to an aircraft and I want to make sure I source the mil-spec or other applicable standard.
  12. Bartonrj25

    What is a good rule of thumb for depth to diameter ratio for end mills used to make pockets?

    Just looking for a standard good rule of thumb. Not a super detailed explanation of different scenarios. Thanks!
Back
Top