ABAQUS error

[jj89]

Hi every one,

i'm new in ABAQUS, and i'm trying extrude a bar of aluminium thought a square, I don't know why when I submit the job, it doen't work.
I think it is a problem related with the related surfaces.
Could anyone see the attached document of Abaqus.

Thank you too much!

 

[Mustaine3]

Your contacts are added in the second step, so in the first step your parts don't know each other and you get rigid body modes.

 

[jj89]

Thank you Mustaine3!! just to be sure and I understood what you mean, what I have to do is to add the "interactions" in the "initial" step and remove the "interactions" that i did from the step "contacto" right??

 

[IceBreakerSours]

Assigning interactions in the initial step should carry over to the next step (unless you choose to deactivate them).

Are you new to this forum? If so, please read these FAQ:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083