Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Acceptable Editions of Referenced Standards (VIII-1 Table U-3) 1

Status
Not open for further replies.
pperlich

pperlich

Mechanical
Jun 17, 2014
114
Is it permissible to use products produced to a newer edition of a standard referenced in Section VIII, Div. 1, Table U-3?
For example a flange built to B16.5-2017?

Phil
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Please see code case 2955 which address this exact question...

Cheers,
Marty
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mechengineer
  • Locked
  • Question
ASME VIII-1 Appendix 2 and ASME PCC-1 with API 660 table 3
Replies
0
Views
203
mechengineer
mechengineer
kremenco
  • Locked
  • Question
U-2(g)(1)(-a) and Appendix 46 of ASME Sec VIII Div 1
Replies
3
Views
182
kremenco
kremenco
AH_AK
  • Locked
  • Question
Smooth Bar S-N Curves (VIII.2-3-F.1.2)
Replies
2
Views
114
AH_AK
AH_AK
jayinwww
  • Locked
  • Question
ASME Sec VIII Div 1 full pen weld on a mixer 1
Replies
4
Views
313
weldstan
weldstan
YuJie_PV
  • Locked
  • Question
why not include ASME B16.21 in Table U-3 of sec VIII-1?
Replies
0
Views
33
YuJie_PV
YuJie_PV

Part and Inventory Search

Sponsor

Back
Top Bottom