Another Hilti Profis Question 1

[JStructsteel]

I paid for the subscription for Hilti Profis. Works great.
Only question I have, is if I dont want to use a profile for analysis, how do I tell the program that? I turn off the profile, then it tells me a profile must be added in order to do the calcs.
am i stuck doing it with a profile? I figure there has to be a way to go back to plain old anchor only design.

 

[WesternJeb]

It sounds like you are in the "Advanced Anchor Plate Design" portion of the software. You can change this by assuming a rigid base plate in the following area:

 

[JStructsteel]

WesternJeb, thanks, that did it.
Jim