Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Any ideas on how to get my home built engine working?

Status
Not open for further replies.

HowToLou

Mechanical
Dec 10, 2012
9
Wow. I never thought I would find a forum like this. This seems a perfect fit for my project. I am building an engine from scratch, using only off-the-shelf parts from a hardware store, and without using any power tools beyond a drill, saw, and sander. I have gotten pretty far, but would like any suggestions on where to go from here. I am getting gas in, and getting spark, because it will do a few revolutions, but I can get it to 'run'. Here is a short video of what I have so far and a couple of demo runs. Thanks, in advance for any insights.

Link

By the way, I have a MS in ME, and a Phd in Hacking [smile], but neither of these has gotten me through this project.
 
Replies continue below

Recommended for you

i admire your determination,however i think this project is a waste of your time.
your time could be better utilized in drinking beer and chasing women.
just sayin'
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor