I am designing a 54" Appendix 2 flange and am trying to size the fillet radius 'r' in Figure 2-4. My flange resembles the one in sketch 6 of 2-4. Note (3) at the end of Figure 2-4 says "Fillet radius r to be at least 0.25 g1...". My g1 is 4.75" thick, giving me a radius of 1.188". Yet in sketch 12(a) above a 3/8" radius is fine if I designed the flange more like an HB forging. Am I misreading Note #3?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Appendix 2 Flange fillet radius
- Thread starter OnG_Engr
- Start date
Similar threads
- Locked
- Question
- Locked
- Question