Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Applying Temp table

Thread starter tp13
Start date Mar 15, 2004

Status: Not open for further replies.

Mar 15, 2004

tp13

Mechanical

This is a beginner problem i'm sure. I am trying to simply apply temperatures 1 through 100 to the corresponding nodes 1 through 100. I have read all of the help, such as the *VREAD and *VGET, and was unable to understand it. I have an excel spreadsheet that I could change to ASCII and bring in if someone could lead me in the right direction. Any help about my particular problem or applying temperature arrays in general would be greatly appreciated.