Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ASME section VIII div.1 2,3
- Thread starter tananT
- Start date
Guidebook for the Design of ASME Section VIII Pressure Vessels, Third Edition
tananT, briefly, Div 1 provides relatively simple and conserative design rules applicable to a broad range of vessles.
Div 2 provides a more analytical approach and can result in cost savings due to the less conserative design.
And as RCHandy says, Div 3 is is used for high pressure vessels, where Div 1 rules are not so suitable.
Regards,
Mike
Div 2 provides a more analytical approach and can result in cost savings due to the less conserative design.
And as RCHandy says, Div 3 is is used for high pressure vessels, where Div 1 rules are not so suitable.
Regards,
Mike
tananT,
Check this link which I found on the internet.
page 23, 24, 25 would give you some information.
Check this link which I found on the internet.
page 23, 24, 25 would give you some information.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question