ASME Y14.5 For Inspection? 5

[BARM]

Hi All,

Is there a standard for inspection of parts made to drawings produced using ASME Y14.5?

Example. I produce the drawing but is my inspector working to a standard for checking the parts?

Thanks,

---SolidWorks 2008 SP3.0---

 

[ewh]

Will Y14.43-2003 become effectively obsolete with the new Y14.5?

Believe it if you need it or leave it if you dare. - [small]Robert Hunter[/small]

 

[Brandy7]

No, actually they are very much the same except for a few changes that will not affect the Gaging Standard, verification of maximum material condition (MMC) size envelopes and virtual condition boundaries generated by geometric tolerances controlled at maximum material condition are still the same. These practices focus on the design of receiver-type gages.