Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Y14.5M-1982 # OF DECIMALS IN FEATURE CONTROL FRAME

Status
Not open for further replies.
tootallbob

tootallbob

Mechanical
Apr 2, 2008
4
We are still using ASME Y14.5M-1982 for our commercial drawings. When using a feature control frame on a inch dimension, does the number of decimals in the F.C.F have to be the same number as in the dimension/tolerance it is attached to?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
May get a better response in forum1103



KENAT, probably the least qualified checker you'll ever meet...
 
Upvote 0 Downvote
thread1103-213601 Meant to say I've only worked to the 1994 standard.



KENAT, probably the least qualified checker you'll ever meet...
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ShlomoB
  • Locked
  • Question
Adding the same balloon multiple times in a drawing (ANSI) 1
Replies
3
Views
2K
ewh
ewh
I_seek_knawledge
  • Locked
  • Question
Y14.5 Basic Dimension & feature control frames
Replies
1
Views
180
ewh
ewh
fabeljafla
  • Locked
  • Question
API Source Inspector Electrical Equipment (SIEE) help ............
Replies
0
Views
692
fabeljafla
fabeljafla
engr2GW
  • Locked
  • Question
ASME B16.5 flange pressure and temperature rating 1
Replies
2
Views
748
4T4
4T4
Bohimei
  • Locked
  • Question
Question about adequacy of a V-notch weir
Replies
0
Views
127
Bohimei
Bohimei

Part and Inventory Search

Sponsor

Back
Top Bottom