Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Y14.5M-1982 # OF DECIMALS IN FEATURE CONTROL FRAME

Status
Not open for further replies.

tootallbob

Mechanical
Apr 2, 2008
4
We are still using ASME Y14.5M-1982 for our commercial drawings. When using a feature control frame on a inch dimension, does the number of decimals in the F.C.F have to be the same number as in the dimension/tolerance it is attached to?
 
Replies continue below

Recommended for you

May get a better response in forum1103



KENAT, probably the least qualified checker you'll ever meet...
 
thread1103-213601 Meant to say I've only worked to the 1994 standard.



KENAT, probably the least qualified checker you'll ever meet...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor