Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Assembly sketch

Status
Not open for further replies.

Andreaschar

Mechanical
Dec 5, 2013
9
Hello,

I have a sketch that I want to add in an assembly in order to model it as a 1D element during simulation. When I click to add part and select the part (sketch), it does not appear in the assembly.

Thanks
 
Replies continue below

Recommended for you

Hi,
Please check the reference set (i guess it is set to MODEL in your case). Change it to Entire Part.
Best Regards
Kapil
 
Or if there are other objects in the Sketch file file that you do NOT want to see in the Assembly other than the Sketch itself, then in the part file contining the Sketch, edit the 'Model' Reference Set so that it ONLY contains the Sketch and its curves.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor