Base Line Dims

[SiW979]

Is there any way to explode baseline dimensions in NX4 so they move independantly, or is it a case of delete and add single ones. I can't find anything obvious.
Many thanks in advance

Best regards

Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX6.0.3.6 MP2 native)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...

 

[uwam2ie]

I try this delete:
from outside the baseline dimensioning mark a single dimension an hit delete.
for add:
activate the baseline dimension set an add the edge you want to dim.

 

[SiW979]

If you delete a single dimension, all the others still remain as base line dimensions and the offset is still associative, or have i missed something?


Best regards

Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX6.0.3.6 MP2 native)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...

 

[uwam2ie]

hey simon,
thats the mess with controlled origns:
when you use during dim. placement - on the placement toolbar the Icon with A and the chains turn it off - thats all

 

[SiW979]

OK with you now, I see what you mean.

Best regards

Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX6.0.3.6 MP2 native)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...