GabiM
Mechanical
- Sep 22, 2008
- 7
Hello,
First of all, i am using NX 4.0.4.2
I would like to know if is possible to create a Blend tangent to 3 faces. A command similar with the drawing TTT (tangent-tangent-tangent), but in model enviroment, between 3 faces.
What i have done is midsurface comand (or a plane) through the middle surface and intersect. I created 2 blends with Face Blend using that line (result of intersection comand) as tangent curve. The result is a TTT blend but was done in more operations and there is a line visible in the middle (not edge, only a visible line, the end of those 2 connecting blends).
I have attached a picture for better understanding.
Can this be done in one comand only? Or, is there a better way to do it?
Thanks,
Gabi Maiug
Mechanical Design Engineer
First of all, i am using NX 4.0.4.2
I would like to know if is possible to create a Blend tangent to 3 faces. A command similar with the drawing TTT (tangent-tangent-tangent), but in model enviroment, between 3 faces.
What i have done is midsurface comand (or a plane) through the middle surface and intersect. I created 2 blends with Face Blend using that line (result of intersection comand) as tangent curve. The result is a TTT blend but was done in more operations and there is a line visible in the middle (not edge, only a visible line, the end of those 2 connecting blends).
I have attached a picture for better understanding.
Can this be done in one comand only? Or, is there a better way to do it?
Thanks,
Gabi Maiug
Mechanical Design Engineer