Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations Toost on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Break view section in Drawing NX7.5

Status
Not open for further replies.

Weinstein

Industrial
May 21, 2013
14
Hello,

I'm trying to create a break view section of a projection view. my problem is that I can't select the chain of curves around my projection.

did this problem occur often and does anybody have a solution?

thank you very much in advance.
 
Replies continue below

Recommended for you

I guess you mean Break-Out Section View and not View Break.
If so, did you create your curves in the view? If you draw curves with sketch commands, did you select Activate Sketch View first? Or did you draw your curves directly on the Sheet?
 
Yes that's what I meant.
While in drawing I used the direct sketch tool to draw the curves.

I did skip the selection of the corresponding view, I did it now and it works very well. so thank you loads.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor