Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

can any one advise me the method to

Status
Not open for further replies.

prasenjith

Mechanical
Feb 12, 2018
15
SA
can any one advise me the method to make design calculation for a blind flange with NPT port ?
 
Replies continue below

Recommended for you

prasenjith, it would help a lot if you would state your Code of Construction, if any. Piping? Vessel? US Code? Foreign Code? Custom blind? B16.5 blind?

ASME B16.5 permits blind flanges to have a centrally located tapped hole up to certain sizes, I believe. Otherwise you are likely falling under the Code of construction.

Regards,

Mike


The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
i think u should go for ug-39 in asme bpvc sec viii div.1 if u r using this code of design and construction
 
SnTman
It’s Api 6a blind flange with npt port in the centre
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top