CarbonWerkes
New member
Hi
I am experimenting with aerodynamic aids for a vehicle. I have found it difficult to isloate lift/downforce components by object, since the objects already include an atmospheric force component.
What I was hoping to do was to run the same mesh with two different inlet conditions (i.e. near zero speed, and then target speed of perhaps 100 km/hr). I would then like to 'combine' these results as deltas in the Post Processor, so that I can see only the differences caused by the change in inlet speed. I was able to do this in another CFD package, but am not sure if it is possible in CFX.
Anyone have a clue about how I might accomplish this?
Best,
Roland
I am experimenting with aerodynamic aids for a vehicle. I have found it difficult to isloate lift/downforce components by object, since the objects already include an atmospheric force component.
What I was hoping to do was to run the same mesh with two different inlet conditions (i.e. near zero speed, and then target speed of perhaps 100 km/hr). I would then like to 'combine' these results as deltas in the Post Processor, so that I can see only the differences caused by the change in inlet speed. I was able to do this in another CFD package, but am not sure if it is possible in CFX.
Anyone have a clue about how I might accomplish this?
Best,
Roland