Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Change tabs bar posiotion to "centered"

Status
Not open for further replies.

MANox

Mechanical
Apr 2, 2007
121
Hello,

I was changed two monitors to one 45 inch.
Before I had NX windows on firs monitor and part, assembly and constraint navigator on second.
And tab bar with icons occupied all width of first monitor.

Now tabs bar with icons is on left part of monitor.
Is it possible to change tab bar from "left" to "centered"?

Best regards

MANok
NX2027
TC14
 
Replies continue below

Recommended for you

Thanks,

maybe this is the best solution...

Best regards

MANok
NX2027
TC14
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor