Changing decimal place in V5 hole table 1

[sleske]

O.K. Here's the problem. Did work on a job and dim'd everything out in MM. Now, we generate hole charts when we draft out the tools. Of course, the chart is in MM's, But, the customer wants the hole chart in inches. Now, I've figured out how to generate the chart in inches, but it only goes out 2 decimals places. How do I change how many decimal places the chart generates?

Thanks,

Sean

 

[sleske]

Found out I'm an idiot. The simplest of answers is, of course, the right answer. Took me 3 hours and my boss 10 min. to figure out I need a vacation.
Thanks to any who may have been trying to figure this out.