circle look like rectangle

[bullthot]

Hello everyone,
I`ve got a problem with view in model. I receive an assembly in which was made a circle, but on model it look like rectangle. When I click on "Information" and next "Object" and I mark this "circle" the information which I receive is "ellipse".
I supposed that constructor apply some simplification... Could someone help what should I do, to see a circle, not rectangle

Best regards

 

[MickyV007]

Goto Preferences - Visualization - Faceting - there you will find 2 Tolerance fields , change this into fine or extra fine and see if it makes any difference.

Best regards,

Michaël.

NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit

 

[bullthot]

unfortunatly this not working... the effect is still the same...

 

[SiW979]

are you loading light weight representations? can you right click on the part and chose "show exact" which will load the full model data rather than just a faceted representation?

Best regards

Simon NX7.5.4.4 MP5 - TC 8

http://www.jcb.com

 

[Walterke]

What type of file is the model? Is it an NX model, an imported step, ...?

NX 7.5
Teamcenter 8

 

[bullthot]

This is NX 7.5 and I can`t click show exact because there isn`t this function.. I imported this from Teamcenter... Someone told me,t that surface is a little sloped ...

 

[joycejo]

Try Preferences - Visualization - line - curve tolerance and see what is set.

John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3

 

[cowski]

Forcing a view regeneration usually helps: View -> Operation -> Regenerate Work.

http://www.nxjournaling.com

 

[bullthot]

ok thanks for help. I will try do it tomorrow and I will write about results

 

[bullthot]

hello all. I find the way why it looks how it looks. If I open this model in UG using TC 8. But if I export this part like a parasololid or using function "export from TC" and next close UG, and open "normal" UG this hole look like a hole, but I can`t measure radius because some how during this export, sketch didn`t export. Could any one help me? Please...