Convert GSD spline to Part sketch

[bob192]

Hello,

I used the GSD_PointSplineLoftFromExcel file to create a spline. It has imported into the part as a "GeometricalFromExcel" Object.

I can't move or edit the points or spline that were generated. My desire is to move this spline around as you would any line that you create in a Part sketch. I eventually will join this spline with other lines to create a bell. I do not want to create a wire-frame; which i understand is what GSD is used for?

Attached is a picture of what the specification tree looks like.

Thanks for the help,

Bob

 

[iscariot]

Isolate the points and you should be able to move them as you wish. (Right click and Isolate)

 

[bob192]

"Isolate the points and you should be able to move them as you wish. (Right click and Isolate)"

I isolated the spline but was not permitted to move it.

 

[LWolf]

drop the compass on the isolated geometry, when it turns green use it to move the object(s).

regards,
LWolf