We are in the process of planning our upgrade tfrom SW2003 to SW2004. Does anyone know of a way to convert an existing part created in SW2003 to a Weldment so that we can create a cut list for it?
Thanks,
Janet
I cannot think of any way to convert a previously modeled weldment into the weldment environment of SW2004, other than very manual procedures. One thing that might help if you used toolbox items to create a weldment assembly in SW2003 is to use the Save As-Part, from the assembly. This will create a multi body part from which you can create your new weldment design layout.
Sorry, I wish that I could think of an easier procedure.