Copy front view from Drafting module to a sketch in Catia V5.

[iamoxygen]

Would you guys show me the way to copy 2d generative drafting to a sketch in Part Design ? I've tried the way in this video but nothing happened after paste command .

 

[dougsnell]

> Save the Drawing as a DXF
> Open the DXF File
> Copy the Geoemtry from the DXF
> Switch to a CATPart in Part Design workbench
> Create a Sketch
> With the Sketcher Workbench open, Paste the Geometry into the sketch

--Doug

 

[iamoxygen]

It still doesn't work for me.
Can you give me some step-by-step pictures ?

 

[itsmyjob]

isolate the view

select the view (not the content in the view, but the view) = copy

go in catpart = paste

Eric N.
indocti discant et ament meminisse periti ​

 

[iamoxygen]

Paste error : It is not allowed to paste . This dialog shows up .

 

[itsmyjob]

Are you sure you copy the view ?

Eric N.
indocti discant et ament meminisse periti ​

 

[JeniaL]

itsmyjob right. check if you are copying the view..any way the macro can do the job.. i don't have it at home but i'm gonna upload the macro at Sunday when i get back to work.

 

[iamoxygen]

Yes, i did copy the view . And if you isolate the view, the content in the view would turn into black.

Is there any difference between your version and mine ?