Aug 17, 2004 #1 panapat Mechanical Aug 12, 2004 4 Is there a rule-of-thumb for the size that a coupling is bored and keyway is broached over the OD of the shaft?
Is there a rule-of-thumb for the size that a coupling is bored and keyway is broached over the OD of the shaft?
Aug 18, 2004 #2 A Artisi Mechanical Jun 11, 2003 6,474 Sure there is, ask the coupling manufacturer for the dimensions and tolerances for your particular shaft size. International College Naresuan University Phitsanulok Thailand Upvote 0 Downvote
Sure there is, ask the coupling manufacturer for the dimensions and tolerances for your particular shaft size. International College Naresuan University Phitsanulok Thailand
Aug 21, 2004 #3 scalleke Mechanical Jun 12, 2003 93 Is this not just listed in the machinery's handbook? Scalleke Upvote 0 Downvote
Aug 24, 2004 #4 tstead Nuclear Aug 10, 2000 109 Regardless of the existance of a "rule of thumb" you need to contact the coupling mfgr for their recommendation just as Artisi said. Don't guess. If it's worth doing, its worth doing RIGHT. Tim S. Upvote 0 Downvote
Regardless of the existance of a "rule of thumb" you need to contact the coupling mfgr for their recommendation just as Artisi said. Don't guess. If it's worth doing, its worth doing RIGHT. Tim S.
