Create fillet Through curve 2

[TiagoFigueiredo]

I want to make a fillet which its value follows a curve

for this case, the result should be a variable radius, with its value in each point, the value from distance, from edge to curve.

Something like CREO does:

https://youtu.be/fqRgxCKD-_g?t=334

Tiago Figueiredo
Tooling Engineer

Youtube channel:

https://www.youtube.com/channel/UC1qdlBeJJEgMgpPLVJoOIOw

 

[rickyt]

Try the Face-Face Fillet.

Choose two surfaces (one from each side of the hard line)
Choose your curve as the "Hold Curve"
and choose a spine.
Your existing curve might work as the spine as well.

 

[LWolf]

The hold curve will give you a symmetrical variable fillet, i.e. both faces will follow the (one) hold curve. If you want to specify a curve for each face, try the styling fillet (which is capable of two hold curves, one for each face)

regards,
LWolf

 

[TiagoFigueiredo]

Thanks!

I had to make the complete loop by 2 times. It was making some errors with the complete profile! Done by 2 times, the result was ok!


Tiago Figueiredo
Tooling Engineer

Youtube channel:

https://www.youtube.com/channel/UC1qdlBeJJEgMgpPLVJoOIOw

 

[jackk]

I'd like to see the result Tiago

 

[TiagoFigueiredo]

Yes, off course.

here it is!

Tiago Figueiredo
Tooling Engineer

Youtube channel:

https://www.youtube.com/channel/UC1qdlBeJJEgMgpPLVJoOIOw