Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Create groove with NXOpen

Status
Not open for further replies.

prok20081

Computer
Apr 22, 2022
4
Hey guys.
Are there any examples of building a groove using C#, C, VB etc?
I tried to journal it, but NX journal does not record functions, properties, when I trying to insert a groove.
 
Replies continue below

Recommended for you

Are you using the old "groove" command?
If so, look into the CreateBallGroove, CreateRectGroove, and CreateUGroove functions. I couldn't find any example code in the Siemens solution center.

www.nxjournaling.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor